Samsung Dryer ✅ Safe for Now

Samsung Dryer Error Code tE4

Samsung Dryer error code tE4: Thermistor error (inlet sensor).

Last reviewed: Aug 7, 2026 Last updated: Aug 7, 2026

Methodology: Reviewed against official Samsung dryer support guidance, then grouped by fault family before separating owner-safe checks from technician-level diagnosis.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Samsung Support - Dryer error codes and troubleshooting — Official Samsung support guidance for dryer error codes, heating, venting, door, sensor, and power troubleshooting.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?

✅ No — safe for now

Safe — unit stops when it can't fill. Check the supply hose and valve before calling a technician.

Can I fix it myself?

DIY Possible

Part: Water inlet valve / supply hose

How much will it cost?

DIY: $15–$80 (inlet valve)

Technician: $100–$250

⏱ 20–40 min

What Does Error tE4 Mean on Your Samsung Dryer?

Samsung Dryer error code tE4: Thermistor error (inlet sensor).

What typically fails: Water inlet valve / supply hose

What You're Probably Seeing

→ Error code displayed
→ Dryer not completing cycle
→ Clothes still wet after full cycle

Common Causes

• Heating element, gas valve, or heater relay not operating correctly
• Airflow restriction causing temperature readings outside expected range
• Thermistor, thermal fuse, or high-limit sensor fault

How to Fix It Yourself

1 Unplug the dryer for 60 seconds then plug back in — this resets the control board and clears many temporary faults
2 Check that the water supply valve behind the machine is fully open
3 Inspect the inlet hose screen filter — sediment often blocks it (unscrew hose, clean mesh screen)
4 Test the water inlet valve with a multimeter — replace if no continuity ($15–$80 part)
5 Test the sensor with a multimeter — check resistance against the spec in the service manual

🛠️ You'll need: Screwdriver set, Pliers, Multimeter · Time: 20–40 min

💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Samsung Dryer error code tE4 mean? ▼

Error code tE4 on a Samsung Dryer means: Thermistor error (inlet sensor). The appliance detected this condition and has stopped or limited operation to prevent further damage.

How do I fix Samsung Dryer error code tE4? ▼

First, unplug the dryer for 60 seconds to reset the control board. If error tE4 returns, the root cause (thermistor error (inlet sensor)) needs to be addressed — check connections, filters, and hoses before calling a technician.

Is it safe to use my Samsung Dryer with error code tE4? ▼

It depends on the cause. Most tE4 errors mean the appliance has stopped itself as a safety measure. Check the 'Should I unplug it?' section above for specific guidance on this error.

More Samsung Dryer Codes

All Samsung dryer error codes → All Samsung appliance codes →