P0302: Cylinder 2 Misfire Detected

P0302 is a diagnostic trouble code indicating: Cylinder 2 Misfire Detected. This code relates to the ignition system system. It has been reported in NHTSA complaints across 42 different vehicle models.

The ECU detects cylinder-specific misfires by monitoring crankshaft acceleration patterns. Each time a cylinder fires, the crankshaft accelerates slightly. When a specific cylinder consistently fails to produce that acceleration, the ECU identifies it. A flashing check engine light during misfires means the catalytic converter is at risk of damage from unburned fuel. Cylinder-specific misfire codes are actually easier to diagnose than random misfires (P0300) because you can use the swap test to isolate the failing component.

The ECU detects misfires by monitoring crankshaft acceleration patterns using the crankshaft position sensor. Each time a cylinder fires, it produces a small acceleration of the crankshaft. When a cylinder fails to fire, the crankshaft actually decelerates slightly during that cylinder's power stroke. The ECU can identify which cylinder misfired based on the timing of the deceleration. A flashing check engine light during active misfires is an emergency — it means the misfire rate is high enough to damage the catalytic converter. Raw, unburned fuel from misfiring cylinders enters the converter, causing it to overheat (temperatures can exceed 1800°F, versus normal 800-1200°F). Common affected vehicles: Any vehicle, but misfires are especially common in: Toyota (ignition coil failures on 4-cylinder engines), Honda (valve adjustment issues causing misfires), GM (AFM/DOD lifter failures causing single-cylinder misfires), Ford (coil-on-plug failures).

**Step-by-Step Diagnosis for Cylinder 2 Misfire:** (1) The swap test is your best friend: move the spark plug AND ignition coil from cylinder 2 to another cylinder (e.g., cylinder 1 if testing cylinder 2). Clear codes and run the engine. If the misfire moves to the new cylinder, you've identified the bad component (plug or coil). If it stays on cylinder 2, the problem is mechanical: injector, compression, or valve issue. (2) Pull the spark plug from cylinder 2 — its condition tells a story. Wet/fuel-fouled (black, wet) = ignition failure or dead injector. Oil-fouled (oily black) = worn valve seals or piston rings. White/blistered = lean condition or overheating. Normal (light tan/gray) = good combustion. (3) If the swap test is inconclusive, perform a compression test on cylinder 2 and compare to other cylinders. All should be within 10% of each other. Low compression on cylinder 2 indicates a valve, ring, or head gasket issue. (4) Check the fuel injector: swap it with another cylinder's injector and see if the misfire moves. You can also use a mechanic's stethoscope to listen for clicking (no click = dead injector).

**Common Cylinder 2 Misfire Causes by Vehicle:** Toyota 4-cylinder (1AZ/2AZ/2AR): ignition coil failures are extremely common — replace the coil ($25-$80) and plug together. Honda K24: valve adjustment is critical — misfires from tight valves are common if adjustment hasn't been done at 100K-mile intervals. GM 5.3L V8: cylinder 2 misfires in Active Fuel Management (AFM) equipped engines may indicate a collapsed AFM lifter — a known issue requiring lifter replacement ($1500-$3000). Ford 4.6L/5.4L: coil-on-plug failures are extremely common — the boots crack and allow arcing to the plug tube.