🔍
Lennox Heat Pump ⛔ Do Not Use

Lennox Heat Pump Error Code 232

Lennox Heat Pump error code 232: Flame sensor failure.

Last reviewed: Last updated:

Methodology: We combine OEM HVAC documentation with field repair patterns, then review for safety-first troubleshooting.

Sources: HVAC manufacturer documentation, installation/service manuals, and technician-reported repair patterns.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Is it safe?
⛔ No — stop using
Do NOT operate — potential gas or CO hazard. Ventilate the area and call a technician immediately.
Can I fix it?
Technician Required
Repair cost
Pro: $150–$600
⏱ 1–3 hours (pro)

What Does Error Code 232 Mean?

Lennox Heat Pump error code 232: Flame sensor failure.

Part that typically fails: Gas valve / igniter / heat exchanger

Do NOT operate — potential gas or CO hazard. Ventilate the area and call a technician immediately.

Symptoms You May Notice

What the Technician Will Do

🔧 Professional repair required. Do not attempt DIY — this repair requires specialized tools or certification.
  1. 1 Check your owner's manual for model-specific guidance on error code reset procedures
  2. 2 Test the temperature sensor with a multimeter — replace if reading is outside spec
  3. 3 Inspect sensor wiring harness for damage or loose connections
  4. 4 Check that gas supply valve is fully open and gas supply pressure is adequate
  5. 5 Clean the flame sensor rod with fine steel wool — carbon buildup is the #1 cause
⚡ Quick tip: Always try a full power reset first — turn the unit off at the breaker, wait 30 seconds, restore power.

Frequently Asked Questions

What does Lennox Heat Pump error code 232 mean? ▼
Error code 232 on a Lennox heat pump indicates: Flame sensor failure. The unit has detected this condition and has limited or stopped operation to prevent further damage.
How do I fix Lennox Heat Pump error code 232? ▼
Start by powering the unit off for 30 seconds and restarting. If error 232 returns, the underlying cause (flame sensor failure) needs to be addressed. Check wiring connections and filters first before replacing components.
Is Lennox error code 232 serious? ▼
It depends on the root cause. Some 232 errors resolve with a reset. Others indicate a failed component that requires professional repair. Don't continue operating with this error — it can lead to further damage.

More Lennox Heat Pump Error Codes

All Lennox heat pump codes → All Lennox HVAC codes →

Was this page helpful?

Rate the helpfulness of this page