Frigidaire Washing Machine ⚠️ Stop Using

Frigidaire Washing Machine Error Code E35

Frigidaire washer error code E35: Water pressure too high (overfill).

Last reviewed: Aug 7, 2026 Last updated: Aug 7, 2026

Methodology: Reviewed against official Frigidaire washer support guidance, then grouped by fault family before separating owner-safe checks from technician-level diagnosis.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Frigidaire Owner Center - Washer support — Official Frigidaire owner support entry point used to confirm washer support and troubleshooting guidance.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?

⚠️ Stop using it

Turn the washer off and shut the water taps if the tub keeps filling. Overfill can damage flooring and nearby electrical …

Can I fix it myself?

DIY Possible

Part: Water inlet valve / pressure switch hose / pressure sensor

How much will it cost?

DIY: $20–$120 (valve, hose, or pressure switch)

Technician: $120–$300

⏱ 20–40 min

What Does Error E35 Mean on Your Frigidaire Washing Machine?

Frigidaire washer error code E35: Water pressure too high (overfill).

What typically fails: Water inlet valve / pressure switch hose / pressure sensor

What You're Probably Seeing

→ Water level rises higher than normal
→ Washer may keep filling or pause the cycle
→ Overfill alarm or drain sequence starts

Common Causes

• Water supply valve closed or restricted
• Inlet hose screen clogged by sediment
• Failed water inlet valve or low household water pressure

What to Try First

1 Press cancel to stop the fill, then shut off both water supply valves right away
2 Unplug the washer and make sure water stops entering the tub; if it does not, the inlet valve may be stuck open
3 Inspect the pressure switch hose or air trap for soap residue, pinches, or a loose connection
4 Run a clean cycle if heavy detergent buildup may be trapping pressure in the air chamber
5 Leave the washer off until the inlet valve or pressure sensor problem is fixed

🛠️ You'll need: Screwdriver set, Pliers, Multimeter · Time: 20–40 min

💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Frigidaire Washing Machine error code E35 mean? ▼

Error code E35 on a Frigidaire Washing Machine means: Water pressure too high (overfill). The appliance detected this condition and has stopped or limited operation to prevent further damage.

How do I fix Frigidaire Washing Machine error code E35? ▼

Start by stopping the fill and shutting off the water valves. Then inspect the inlet valve and pressure hose because E35 usually means the washer thinks the water level is too high or is still rising.

Is it safe to use my Frigidaire Washing Machine with error code E35? ▼

No. Leave the washer off if it keeps filling or if the tub level is higher than normal.

More Frigidaire Washing Machine Codes

All Frigidaire washing machine error codes → All Frigidaire appliance codes →