Frigidaire Washing Machine ⚠️ Stop Using

Frigidaire Washing Machine Error Code E47

Frigidaire washer error code E47: Door lock overcurrent.

Last reviewed: Aug 7, 2026 Last updated: Aug 7, 2026

Methodology: Reviewed against official Frigidaire washer support guidance, then grouped by fault family before separating owner-safe checks from technician-level diagnosis.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Frigidaire Owner Center - Washer support — Official Frigidaire owner support entry point used to confirm washer support and troubleshooting guidance.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?

⚠️ Stop using it

Door-lock overcurrent can overheat the latch assembly. Keep the washer off until the lock circuit is checked.

Can I fix it myself?

Technician Recommended

Part: Door lock assembly / lock harness / control circuit

How much will it cost?

DIY: $25–$120 (latch or harness)

Technician: $120–$320

⏱ 15–30 min

What Does Error E47 Mean on Your Frigidaire Washing Machine?

Frigidaire washer error code E47: Door lock overcurrent.

What typically fails: Door lock assembly / lock harness / control circuit

What You're Probably Seeing

→ Cycle won't start
→ Door won't open after cycle
→ Error code on display

Common Causes

• Door not fully latched or latch obstructed
• Door lock switch or strike out of alignment
• Loose harness connection at the lock assembly or control board

What to Try First

1 Press pause and make sure the door is fully closed with no item caught in the seal
2 Inspect the door strike and latch opening for cracks, detergent buildup, or a warped boot
3 Unplug the washer and check the lock harness for chafing or heat damage
4 If E47 returns after the door hardware checks out, leave the washer unplugged and have the lock circuit tested
5 Do not force the latch or tape the switch closed

🛠️ You'll need: Screwdriver set, Putty knife · Time: 15–30 min

💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Frigidaire Washing Machine error code E47 mean? ▼

Error code E47 on a Frigidaire Washing Machine means: Door lock overcurrent. The appliance detected this condition and has stopped or limited operation to prevent further damage.

How do I fix Frigidaire Washing Machine error code E47? ▼

Start by checking the door strike, latch, and harness for binding or heat damage. If the hardware looks normal but the code returns, the door-lock circuit needs service.

Is it safe to use my Frigidaire Washing Machine with error code E47? ▼

No. Door-lock overcurrent can overheat the latch assembly, so keep the washer off until the circuit is checked.

More Frigidaire Washing Machine Codes

All Frigidaire washing machine error codes → All Frigidaire appliance codes →