Frigidaire Washing Machine ⚠️ Stop Using

Frigidaire Washing Machine Error Code E71

Frigidaire washer error code E71: NTC sensor in wash circuit failure.

Last reviewed: Aug 7, 2026 Last updated: Aug 7, 2026

Methodology: Reviewed against official Frigidaire washer support guidance, then grouped by fault family before separating owner-safe checks from technician-level diagnosis.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Frigidaire Owner Center - Washer support — Official Frigidaire owner support entry point used to confirm washer support and troubleshooting guidance.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?

⚠️ Stop using it

Avoid repeated hot cycles until the sensor fault is fixed. Incorrect temperature readings can overheat or underheat the …

Can I fix it myself?

DIY Possible

Part: Wash NTC sensor / harness / heater circuit

How much will it cost?

DIY: $10–$60 (sensor)

Technician: $80–$250

⏱ 20–45 min

What Does Error E71 Mean on Your Frigidaire Washing Machine?

Frigidaire washer error code E71: NTC sensor in wash circuit failure.

What typically fails: Wash NTC sensor / harness / heater circuit

What You're Probably Seeing

→ Error code displayed
→ Machine stops mid-cycle
→ Cycle won't complete

Common Causes

• Pressure hose kinked, blocked, or disconnected
• Water-level pressure sensor reading out of range
• Control board not receiving a valid level signal

How to Fix It Yourself

1 Cancel the cycle and switch the washer off before testing another warm or sanitize cycle
2 Unplug the washer and inspect the wash NTC connector and wiring for corrosion, broken insulation, or a loose fit
3 Check the sensor resistance against the Frigidaire service data for your model
4 Replace the NTC sensor if readings are clearly out of range or intermittent
5 If the sensor and wiring check out, have the heater control circuit inspected professionally

🛠️ You'll need: Multimeter, Screwdriver set · Time: 20–45 min

💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Frigidaire Washing Machine error code E71 mean? ▼

Error code E71 on a Frigidaire Washing Machine means: NTC sensor in wash circuit failure. The appliance detected this condition and has stopped or limited operation to prevent further damage.

How do I fix Frigidaire Washing Machine error code E71? ▼

Start by unplugging the washer and checking the wash NTC sensor and harness. If the sensor reads out of range or the wiring is damaged, repair that fault before running another heated cycle.

Is it safe to use my Frigidaire Washing Machine with error code E71? ▼

Avoid repeated hot cycles until the sensor fault is fixed. Incorrect temperature readings can overheat or underheat the wash.

More Frigidaire Washing Machine Codes

All Frigidaire washing machine error codes → All Frigidaire appliance codes →