Maytag Washing Machine ✅ Safe for Now

Maytag Washing Machine Error Code F9E1

Maytag Washing Machine error code F9E1: Drain pump failure — not draining.

Last reviewed: Aug 7, 2026 Last updated: Aug 7, 2026

Methodology: Reviewed against official Maytag washer support guidance, then grouped by fault family before separating owner-safe checks from technician-level diagnosis.

Sources: Manufacturer fault-code sheets, service manuals, and recurring field-repair patterns.

Maytag Product Help - Washer error codes and troubleshooting — Official Maytag Product Help entry point for washer error-code troubleshooting and owner-safe checks.

Limits: Guidance is informational and may not match every model-year or revision. Confirm with the official manual and diagnostics before replacing parts. For safety-critical or electrical work, use a qualified technician.

Should I unplug it?

✅ No — safe for now

Safe to leave off. Fix soon — water backup can cause mold or floor damage.

Can I fix it myself?

DIY Possible

Part: Drain pump / drain hose / filter

How much will it cost?

DIY: $0–$150 (pump or hose)

Technician: $100–$300

⏱ 20–45 min

What Does Error F9E1 Mean on Your Maytag Washing Machine?

Maytag Washing Machine error code F9E1: Drain pump failure — not draining.

What typically fails: Drain pump / drain hose / filter

What You're Probably Seeing

→ Water left in drum after cycle
→ Machine stops during spin
→ Wet clothes after full cycle

Common Causes

• Drain hose kinked, blocked, or installed too high
• Pump filter clogged with lint or debris
• Failed drain pump or loose drain-pump wiring

How to Fix It Yourself

1 Unplug the washing machine for 60 seconds then plug back in — this resets the control board and clears many temporary faults
2 Check and clean the drain pump filter (usually behind a small door at the bottom front)
3 Inspect the drain hose for kinks, blockages, or improper height
4 Test the drain pump — if it hums but won't move water, replace it ($50–$120 part)
5 If the error persists after basic troubleshooting, contact a qualified appliance technician

🛠️ You'll need: Screwdriver set, Bucket, Wet/dry vacuum · Time: 20–45 min

💡 Try this first: Unplug the appliance for 60 seconds, then plug back in. This resets the control board and clears many temporary faults.

Questions People Also Ask

What does Maytag Washing Machine error code F9E1 mean? ▼

Error code F9E1 on a Maytag Washing Machine means: Drain pump failure — not draining. The appliance detected this condition and has stopped or limited operation to prevent further damage.

How do I fix Maytag Washing Machine error code F9E1? ▼

First, unplug the washing machine for 60 seconds to reset the control board. If error F9E1 returns, the root cause (drain pump failure — not draining) needs to be addressed — check connections, filters, and hoses before calling a technician.

Is it safe to use my Maytag Washing Machine with error code F9E1? ▼

It depends on the cause. Most F9E1 errors mean the appliance has stopped itself as a safety measure. Check the 'Should I unplug it?' section above for specific guidance on this error.

More Maytag Washing Machine Codes

All Maytag washing machine error codes → All Maytag appliance codes →